Elesa+Ganter 111343 HVF.114-E-1 Visual Flow Indicator with Sensor

Technical Overview

The Elesa+Ganter 111343 visual flow indicator with sensor, also listed as HVF.114-E-1, combines direct flow visibility with an inductive sensing function. It is designed for liquid-flow monitoring where operators need both visual confirmation and a sensor signal that can be connected to a PLC. This makes the component useful in automated hydraulic, lubrication, cooling, and industrial process systems.

Sensor and Material Design

The HVF.114-E-1 has polypropylene-based technopolymer ends and sensor holder, a red PP rotor propeller, AISI 304 stainless steel sensor-activating clips, and a high-resistance borosilicate glass window. The sensor is a nickel-plated brass inductive sensor with PNP output, 10–30 Vcc power supply, 200 mA maximum load, short-circuit protection, reverse polarity protection, M12x1 4-pole connector, and IP67 protection class.

Flow and Measurement Data

This model has a 1-inch connection, 114 mm height, 70 mm length, 46 mm h1 dimension, and 94 mm l1 dimension. The maximum pressure is 10 bar. Its total measuring range is 2.1 to 60 l/min. The non-linear measuring range is 2.1 to 5 l/min, while the linear measuring range is 5 to 60 l/min. In the linear range, pulse measurement accuracy is listed at ±3%. The unit provides 35 pulses per litre and reaches a maximum frequency of 48 Hz.

Elesa+Ganter 111343 Installation Considerations

To support reliable rotor operation, the circuit should be washed and purged before installation. Clean fluid conditions are important because particles can interfere with rotor movement. Air bubbles may also create measurement errors, so the indicator should ideally be installed before valves or components that may cause cavitation. For more details about Elesa+Ganter solutions, visit Elesa+Ganter.

Elesa+Ganter 111343 FAQ

What is the Elesa+Ganter 111343 HVF.114-E-1 used for?

It is used for visual flow monitoring and sensor-based flow signal reading in liquid systems.

Can the sensor output be connected to a PLC?

Yes. The inductive sensor provides a frequency signal that can be converted into a flow-rate reading through a PLC.

What is the linear measuring range?

The linear measuring range is 5 to 60 l/min.

What protection class does the sensor have?

The sensor has IP67 protection class.